Setup JMRI

• Preparing to Install

Getting Started

• What is DCC?
• What DCC systems will DecoderPro work with?
• What hardware do I need?
• How do I start the program?
• How do I set up my Preferences?

Using DecoderPro

• How do I set up to program a decoder?

DecoderPro® Programming Modes

• What are the Programming Modes?
• Single CV Programmer
• Service Mode Programmer
• Ops Mode Programming
• Multi Decoder Control (Programming)

The Basic Programmer

• Entering Locomotives in the "Roster"
• The basic programmer
• Reading the data from the decoder
• Entering and editing new data
• Writing the new data to the decoder
• Saving the new data to a file
• What if I need to do more?

The Comprehensive Programmer

• Setup and Roster Panes
• Expanded Basic Pane
• Motor Control Pane
• Speed Control Pane
• Speed Table Pane
• Function Mapping Pane
• Lights Pane
• Consisting Pane
• Advanced Features Pane
• Analog Controls Pane
• Sound Pane
• Sound Levels Pane
• Global CV Pane
• Manufacturer-Specific Pane
• Printing the Decoder Data

DecoderPro® Main Window

SPROG Menu

---

Command Monitor

Opens the Communications Monitor Window and automatically displays the information that is being sent and received on the communications link between your computer and your DCC system.

Send Command

Opens the Send prompt with a text box to enter the Command message that will be sent to the DCC system when you click on the Send button.

Console

Opens the Sprog Console window that combines the communications monitor, Send Command and other features into a single user interface.

Get SPROG Firmware Version

Retrieves the SPROG firmware version and displays that information.

SPROG V3/V4 Firmware Update

Starts the SPROG Firmware Update wizard.

SPROG II Firmware Update

Starts the SPROG II Firmware Update Wizard (basically the same as above)

---

SPROG Console

The Console combines the Communications Monitor, Send Command and other features into a single interface.

---