Harman DIY Accessory Decoders decoder definition

Decoder Family: Harman DIY Accessory Decoders

Eight outputs
Two outputs

CV Definitions:

CV	Positions	Values
1
9	XXXXXVVV
1	XXVVVVVV
1	VVVVVVVV
3	VVVVVVVV
4	VVVVVVVV
5	VVVVVVVV
6	VVVVVVVV
1	XXVVVVVV
1	XXVVVVVV
1	XXVVVVVV
1	XXVVVVVV
1	XXVVVVVV
1	XXVVVVVV
1	XXVVVVVV
1	XXVVVVVV
1	VVVVVVVV
1	VVVVVVVV
1	VVVVVVVV
1	VVVVVVVV
1	VVVVVVVV
1	VVVVVVVV
1	VVVVVVVV
1	VVVVVVVV
29	XVXXXXXX
29	VXXXXXXX	Decoder Address Mode Output Address Mode
33	VVVVVVVV
33	XXXXXXXV	Off On
33	XXXXXXVX	Off On
33	XXXXXVXX	Off On
33	XXXXVXXX	Off On
33	XVXXXXXX	Off On
34	XXXXVXXX	Pin 6 Pin 5 or 11
35
35	VXXXXXXX	No Yes
35	XVXXXXXX	No Yes
35	XXVXXXXX	No Yes
35	XXXVXXXX	No Yes
35	XXXXVXXX	No Yes
35	XXXXXVXX	No Yes
35	XXXXXXVX	No Yes
35	XXXXXXXV	No Yes
36
36	VXXXXXXX	No Yes
36	XVXXXXXX	No Yes
36	XXVXXXXX	No Yes
36	XXXVXXXX	No Yes
36	XXXXVXXX	No Yes
36	XXXXXVXX	No Yes
36	XXXXXXVX	No Yes
36	XXXXXXXV	No Yes

Decoder Address Mode To turn off, use Output Address Mode pane In Decoder Address Mode, the decoder address is multiplied by four to get the accessory address. An offset of 1 is required to work with Lenz/Digitrax systems when compared to Roco/MERG command stations Lenz (etc) Command Stations Accessory Address to operate Roco (etc) Command Stations Accessory Address to operate Output Duration and Toggle Mode Toggle Mode is required for some systems, if in doubt, turn on The behaviour is the same as with MERG kit built decoders Duration of Output (x10 MilliSecs) 0 = continous output Toggle Mode Outputs Output behaviours: Output Address Mode To turn off, use Decoder Address Mode pane In Output Address Mode, the decoder address is the accessory address, there is no multiplication. An offset of 4 is required to work with Lenz/Digitrax systems when compared to Roco/MERG command stations Lenz (etc) Command Stations Accessory Address to operate Roco (etc) Command Stations Accessory Address to operate Output Duration and Toggle Mode Toggle Mode is required for some systems, if in doubt, turn on The behaviour is the same as with MERG kit built decoders Duration of Output (x10 MilliSecs) 0 = continous output Toggle Mode Outputs Output behaviours:

This page was produced by JMRI.

JMRI, DecoderPro, PanelPro, DispatcherPro and associated logos are our trademarks.

Additional information on copyright, trademarks and licenses is linked here.