Decoder Family: Series 7 Boards

LOCONETBD7OPSWMODE

CV Definitions:

CVNamePositionsValues
1
    7
      8
        9VVVVVVVV
          11XXXXXXXV
          11XXXXXXVX
          11XXXXXVXX
          11XXXXVXXX
          11VVXXXXXX
          1. 0
          2. 1
          3. 2
          12XXXXXVXX
          12XXXXXVXX
          13XXXVXXXV
          1. 0
          2. 1
          3. 2
          4. 3
          13XXVXXXVX
          1. 0
          2. 1
          3. 2
          4. 3
          13XVXXXVXX
          1. 0
          2. 1
          3. 2
          4. 3
          13VXXXVXXX
          1. 0
          2. 1
          3. 2
          4. 3
          14XVXXXXXX
          16XXXXXXXV
          CVs <html>The "CV" column in the table above shows CV numbers, not the Op Switch number.<p>To see those, hover your mouse over a variable on the OpSw Settings pane. <p>CVs 1 and 2 are the low and high (respectively) 8-bit "Base Address" values.<p>The "Base Address" is practically limited to 2040, max.<p>The "Roster" tool and its Roster entries <em> cannot</em> change the "Base Address". Basic <html> <p>This roster entry will only access the specified board if the Base Address specified above <br>was correctly entered when the roster entry was first created. You <em>cannot</em> change it in the Roster Entry. </html> OpSw Settings <html><h2>Section "Mode" <html><h2>Occupancy Detection <html><span style="color: green;"><em>The "Occupancy Detection Speed" settings, below, apply to PM74 "July 1, <p>2024 (version Rev 7)" and later firmware. Previous firmware versions do <p>not implement these OpSws. <html><h2>Transponding <html><h2>Outputs
          This page was produced by JMRI.

          Copyright © 1997-2024 JMRI Community.

          JMRI, DecoderPro, PanelPro, DispatcherPro and associated logos are our trademarks.

          Additional information on copyright, trademarks and licenses is linked here.